<form id="p17fj"></form>
        <thead id="p17fj"></thead>
        當前位置:網站首頁>沙金設備產品展示 > 組合式砂金設備 > 巖金設備 >處理量30-60噸/小時沙金巖金混合選金處理方案設備清單

        處理量30-60噸/小時沙金巖金混合選金處理方案設備清單

        設備簡介

        本套選金設備為固定式滾筒篩+離心機組合式破碎選金設備,處理量為每小時30-60噸,是我公司根據用戶需求獨立研發制作而成。本套設備運行穩定、故障率低,是當今主流的選金設備,深受國內外用戶的歡迎,其優勢如下:

        1、滾筒篩供水系統采用中央供水+兩側供水,中央供水系統負責沖洗滾筒篩內物料,兩側供水系統負責沖洗外部細篩網,防止堵料。

        2、本套設備技術成熟,故障率低,保養、維護簡單方便。

        3、采用一臺1200#臥式全自動連續排礦離心機,PLC電腦全自動控制無需地面硬化與尋找水平,處理量大,操作簡單方便。

        4、采用2臺振動溜槽進行收尾,防止收金草板結、處理量大。

        Brief Introduction

        This set of gold machine including reamers trommel screen,centrifuge and crushing gold equipment, the capacity of 30-60 t/h, which is our company according to user’s requirements design&manufactured. This set of equipment with easy operation, low failure rate, is the favourite in the market.The advantage as belows:

        1.Central water supply system of Reamers&Trommel Screen Separator is on central and trommel’s both sides.The central is used for material washing, both sides is responsible for washing the mesh to prevent clogging.

        2.As the technology is mature, machine with lower failure rate, simple operation and convenient maintenance

        3.1200# horizontal automatic discharge with no break centrifuge, PLC control without need of seeking balance on ground, simple and convenient operation

        4.The 2sets gold shaking sluice with high capacity can prevent the gold grass to be hardening

        流程概述

        原料通過工程機械送入進料斗,然后通過振動給料機均勻進入一臺鄂式破碎機內進行破碎,破碎后的物料通過一臺上料輸送機進入多鉸刀鉸洗筒內進行鉸泥沖洗,然后進入滾筒篩內進行篩選分級為大于4MM物料與小于4MM物料兩種規格。小于4MM的物料通過滑槽及管道進入盛料箱中;大于4MM的物料進入兩臺巖金礦專用制沙機內進行破碎制沙后進入盛料箱內。

        盛料箱內的物料通過沙泵打入離心機內部進行精選,精料通過精料管道排出;廢料排入兩臺振動溜槽進行收尾后,廢料排入廢料池中。

        Technological Process

        The raw material getting into the hopper by excavator or other, then through the shaking feeder getting into jaw-type crusher to be crushed,the mixture through conveyor into reamers and trommel screen gold separating machine to be separated into 2 sizes,≧4mm≤4mm.The samll size≤4mm getting into mineral box though mineral separating device;the big size≧4mm getting into Sandmaking machine specialized for rockmine to be crushed then into mineral box.

        Mineral in mineral box then getting into 100#centrifuge by sand pump to be separating,concentrate get from concentrate discharging port,scrap material into 2sets of gold shaking sluice for further separation,finally the scrap into waste pool.

        技術參數

        Technological parameter

        名稱
        Product name

        規格
        Specification

        功率
        Power/Kw

        數量
        Quantity

        備注

        上料輸送機
        Conveyor

        皮帶寬度600mm
        Belt width:600mm

        5.5

        1套


        鉸洗式滾筒篩
        Reamers&trommel
        Screen gold separator

        總長度7.4米
        Total length 7.4m
        多鉸刀鉸洗筒長度4.4米,筒徑1.3米
        Reamer trommel Length4.4m,diameter:1.3m
        滾筒篩長度3米,內徑1.3米,外徑1.6米

        Trommle screen length 3m inner dia.:1.3m
        Outside dia.:1.6m

        18.5

        1套

        總長度7.4米

        支架浮體料斗
        Holding frame


        -

        1套


        巖金礦專用制沙機
        Sandmaking machine specialized for rockmine

        800*1000mm

        75*2

        2臺


        離心機
        Centrifuge concentrator

        1200#臥式全自動連續排礦

        21.5

        1臺


        振動溜槽
        Gold shaking sluice

        4500*1320mm

        3*2

        2臺


        離心泵
        Centrifugal pump


        11

        1臺


        離心泵吸水管道
        Water input pipe of centrifugal pump


        -

        10米


        離心泵出水管道
        Water output pipe of centrifugal pump


        -

        50米


        離心機進料管道
        Feeding pipe of centrifuge


        -

        20米


        盛料箱
        Mineral box


        -

        2套


        沙泵
        Sand pump

        4inch

        15

        1套


        沙泵管道
        Pipe of sand pump



        20米


        配電箱
        Electricity cabint



        1套

        含至設備電機線,不含電纜線

        總用電功率
        Total power

        227.5KW(不含其它設備)



        產品分類

        /PRODUCTS

        聯系我們

        /CONTACT

        全國統一咨詢熱線

        0536-3593111

        地址:青州市黃樓街道辦事處西建德村

        電話:0536-3593111

        傳真:0536-3593111

        手機:15053659999,15653473333

        Email:1592999333@qq.com

        版權所有:青州冠誠重工機械有限公司 魯ICP備09020970號-47
        超碰caoporen国产最新地址